LEDs and passives and transistors and switches and op-amps oh my! The Adafruit Parts Pal is the ultimate companion for an entry-level maker learning electronics. This kit is your friend whenever you need to build up a project. It contains many of our most popular components and prototyping parts all wrapped up in one parts pack so you can open up and dig right in.

Kit Contents:

Prototyping:

• 1x - Storage box with latch
• 1x - Half-size breadboard
• 20x - Male/male jumper wires - 3" (75mm)
• 10x - Male/male jumper wires - 6" (150mm)

LEDs:

• 5x - 5mm Diffused green LEDs
• 5x - 5mm Diffused red LEDs
• 1x - 10mm Diffused Common-Anode RGB LED

Capacitors:

• 10x - 1.0uF Ceramic capacitors
• 10x - 0.1uF Ceramic capacitors
• 10x - 0.01uF Ceramic capacitors
• 5x - 10uF 50V Electrolytic capacitors
• 5x - 100uF 16V Electrolytic capacitors

Resistors:

• 10x - 560 ohm 5% axial resistors
• 10x - 1K ohm 5% axial resistors
• 10x - 10K ohm 5% axial resistors
• 10x - 47K ohm 5% axial resistors

Semiconductors:

• 5x - 1N4001 Diodes
• 5x - 1N4148 Signal Diodes
• 5x - NPN Transistor PN2222 TO-92
• 5x - PNP Transistor PN2907 TO-92
• 2x - 5V 1.5A Linear voltage regulator - 7805 TO-220
• 1x - 3.3V 800mA Linear voltage regulator - LD1117-3.3 TO-220
• 1x - TLC555 wide-voltage range, low-power 555 Timer
• 1x - LM358 Dual operational Amplifier

Sensors:

• 1x - Photocell
• 1x - Thermistor (Breadboard version)
• 1x - Vibration sensor switch
• 1x - 10K Breadboard trim potentiometer
• 1x - 1K Breadboard trim potentiometer

Mechanical:

• 1x - Piezo buzzer
• 5x - 6mm Tactile switches
• 3x - SPDT slide switches
• 1x - 40-pin Break-away male header strip
• 1x - 40-pin female header strip