Instead of being a single embedded functional module, Wio Terminal is more of a complete system equipped with Screen + Development Board + Input/Output Interface + Enclosure. Because it uses the SAMD51, it is compatible with Arduino and CircuitPython - using the same Arduino & CircuitPython core we have developed here at Adafruit!

Wio Terminal is an ATSAMD51-based microcontroller with wireless connectivity supported by Realtek RTL8720DN. Its CPU speed runs at 120MHz (boost up to 200MHz). Realtek RTL8720DN chip supports both Bluetooth and Wi-Fi providing the backbone for IoT projects. The Wio Terminal itself is equipped with a 2.4” LCD Screen, onboard accelerometer (LIS3DHTR), microphone, buzzer, microSD card slot, light sensor, and infrared emitter (IR 940nm). On top of that, it also has two x JST PH 4-pin STEMMA / Grove ports for Grove Ecosystem and 40-pin compatible GPIO for more Raspberry Pi add-ons.

Highly Integrated Design

• MCU, LCD, WIFI, BT, IMU, Microphone, Buzzer, microSD Card, Configurable Buttons, Light Sensor, 5-Way Switch, Infrared Emitter (IR 940nm), Crypto-authentication Ready
• Well-designed enclosure with built-in magnets and two mounting holes, allowing you to set up your IoT project without hassle

Powerful MCU - Microchip ATSAMD51P19

• ARM Cortex-M4F core running at 120MHz using Adafruit core support for Arduino and CircuitPython
• 4 MB External Flash, 192 KB RAM
• Comprehensive Protocol Support
• SPI, I2C, I2S, ADC, DAC, PWM, UART(Serial)

Reliable Wireless Connectivity

• Powered by Realtek RTL8720DN
• Dual Band 2.4Ghz / 5Ghz Wi-Fi (802.11 a/b/g/n)
• BLE / BLE 5.0

USB OTG Support

• Accessible Devices (as USB-Host): read data or signals from a mouse, keyboard, MIDI devices, Xbox/PS gaming controllers, 3D printers
• Simulated Devices (as USB-Client): emulate a mouse, keyboard or MIDI devices to Host PC
• When using USB Host/Client function, you can use the 40-pin on the back of Wio Terminal for power supply. Check here for detailed instructions.

External Sensor Ports

• Two onboard multi-functional Grove ports can be used for Digital, Analog, I2C, and PWM
• To connect STEMMA QT sensors with Wio Terminal, please use a JST PH 4-pin STEMMA / Grove cable.

Raspberry Pi 40-pin Compatible

• Can be mounted to a Raspberry Pi as a peripheral device
• Raspberry Pi's HAT can be used with an adapter cable

Software Support

• Arduino based on Adafruit SAMD51 core
• Adafruit CircuitPython (How to run CircuitPython on Wio Terminal?)
• ArduPy
• AT Firmware
• Visual Studio Code