This simple Translucent Snap-on Case is both good looking and tough enough to toss into your bookbag or toolbox. It has slim cut-outs for your cable, speaker, and battery. It's translucent plastic so you can still easily see the micro:bit PCB markings and LEDs shining through. The bottom section is open so you can plug it into a micro:bit accessory.

This case is great if you want to protect your micro:bit v2 board from everyday usage, but note that it is not waterproof or weatherproof. This enclosure comes as 2 molded plastic halves.

No boards, cables, or accessories are included. Designed for the micro:bit V2 only! If you want the V1 case, check that out here